Creative Deco10 x A3 Birch Plywood Sheets | 420 x 300 x 3mm Baltic Wood Ply | Perfect Board for Wood DIY Home Decor, Arts, Craft, Painting, Laser Cutting, CNC, Scroll Saw, Stenciling Pyrography

Decent quality but not cheap with some boards badly warped. Not very impressed. Will probably not buy again or recommend.UPDATE: To be clear, I like to try and give honest feedback and not just use the platform to make complaints. I tend to do that directly.Following my 'review' I was contacted out of the blue by the supplier who was concerned by my original feedback above.There was no fuss, but rather an offer to send some more sheets to cover the faulty part of my order.I find this proactive approach both refreshing and admirable, not to mention unusual. It is for this reason that I have altrered my rating to 5 stars.Yes, there was an inconvenience but it has been rectified through no effort at at all on my part and I do appreciate when people make an effort and give recognition for it!

It was OK for my requirements, but could have been sanded a little better

Product was just about acceptable but was a bit warped and twisted upon openingWas impossible to use on big parts but OK for the smaller bits

No good for lazer engraving to much glue

I use these to cut shapes with a laser. Good results until you produce items with 0.25 inch width. They then become very fragile even a small bump can cause a break.

Purchased ten A3 Baltic birch plywood sheets to laser cut on the Glowforge. Eight out of ten of the sheets - as in every one but for those visible on the outside of the pack - are unusable for the large project I'd intended them for due to what looks like a gift tag pattern lightly engraved in the birch veneer. Several of these also had tear-out where the (very thin) veneer has been planed to thickness. And every single one of the ten sheets bowed like rowboats the second they were released from the strapping surrounding the pack.An utterly appalling product. Funnily enough, I had quite the opposite experience with Creative Deco's A4 Baltic birch plywood, but given this level of quality control I'll be buying my materials from another supplier in future.

I wasn't expecting these to be the best, I buy a lot of 3mm Birch ply for laser cutting and engraving but they're excellent quality! Well packaged with very little warp, and cut really well, very few glue spots. The only slight annoyance is the stickers on one side of one sheet in the pack, they're difficult to remove and leave a sticky residue. I sanded it off in the end. Will buy again!

These are the perfect size for my 10W laser cutter bed. They arrived quickly held together with plastic wrapping tape. However, once the tape was removed the boards warped quickly.I clamped them down to the laser bed to make them flat for cutting and have had 4 failures out of 9 attempts. Most of the pattern was cut all the way through but enough had not penetrated the board to make it impossible to rescue the jobs.When I did try and rescue one job there was a large knot in one layer that made it impossible to recover. I have attached a couple of pictures to illustrate the issue.I had to slow down the speed so much that it was taking in excess of an hour to complete each job.I cannot recommend these to anyone thinking of using them for laser cutting as the amount of wastage is just too high.