Patio Gas Regulator 27Mm Clip On With 2M Hose + 2 Clips Fits Calor/Flogas

I've recently been building a new outdoor cooking space and during this process I found that the gas regulator on my BBQ had developed a bit of a sealing issue and needed to be replaced. My BBQ is getting on a bit now and the original gas supply hose had hardened up due to exposure to the elements, plus was not quite long enough for the new position relative to the gas supply. Time to change that too. Instead of ordering separate hose, gas regulator and jubilee clips I ordered this kit. It's perfect for the job and the hose is long enough (3m) to be cut exactly to size for a nice neat installation. All seem to be of good quality.Pro-tip: Soak the hose ends in hot water for 5mins to soften the rubber enough to push over the hose barbs easier.

Cheap as chips…. fits and works well, the alone must be over half the price. I bought for a continent butane bottle that full, cheaper to buy a regulator than replace. It works fine on my BBQ, pressure if correct is higher as it’s designed for LPG which is 37mb Butane is normally 29mb.Very easy to fit and remove too no tools needed and only 1 hand.Delivery was quick to.

Fits easily, but after 6 months occasional usage it has become stuck on the Calor Patio Gas cyclinder. I've tried all position of the control lever, but no release. It's looking like I may need to get the dremel out and cut it off when the gas is exhausted. It was releasing when I first installed it, so I suspect there some corrosion preventing it from unlocking.

Comes with a good length of hose, clips and the regulator itself. The regulator fits a full-size (14kg) patio gas bottle easily, with no issues with clearance. It's easy to fit and is secure once attached. One thing I quite liked is that the on/off knob has a little flame on it which allows you to easily know if your gas is on or not!All in all does the job well, for a good price, what more can you ask for?

Seems good quality, easy to fit, works perfectly

Great bit of kit

Not expensive and contains the connector, a hose about 2m long, and two ring tighteners - everything you need to connect up a gas device. Tip: use a little soap on the connector, and put the hose in freshly boiled water to soften it, to get the hose to easily slip over the connector. Dry and cold is very difficult! I'm very happy with the kit, it let me connect my 10kg Flogas to my burner.

I found it impossible to get the supplied hose fully onto the regulator attachment, even after placing it in hot water for 5 minutes to make it more pliable. In the end, I only used the regulator and used the hose my BBQ was supplied with, works perfectly.