Baomain Power Relay MK2P-I 110VAC Coil DPDT 8 Pin with Plug-in Terminal Socket, for Automation and Control Systems

WORKS GREAT

Exact replacement

Relay was supposed to be 110 volt coil. Hooked it up on 120 volt and it just sat there and hummed. Relay contacts would not close. Just more junk from china.

might work for intermitant use but really get hot and will melt down if left energised.

Work grate

contacts burned in first day n of use. Tested ok ok install, but failed next day. 4.6 amp running load on 230v single phase motor. Maybe starting amps just too big for this relay

My company has been using these relays in this manner for many years now. My most current load is around 6.5 amps and they usually last for several years. For whatever reason, the ones offered here just don't cut the mustard. The second picture failed in less than two days and ended up costing me a days worth of labor and fuel to drive about 200 miles to replace it at no cost to my customer. I swapped it with an Eaton and had no further issues. I have a few left from the "great deal" of my last order but I am considering placing them in the trash. It will save me money in the long run.

Bought two realys both went bad in less than a month. Check power had good voltage. One made the contactor chatter work for three weeks. The other lasted two days and would not work. Put sq d in two weeks ago no problem. Dont be cheap like I was spend the money on name brand.