Illuminate Your Drive! 💡
The YUMSEEN H4 HB2 9003 LED Headlight Canbus Error Anti-Flicker Resistor Canceller Decoder is designed to enhance your vehicle's lighting system. With a genuine Can-Bus decoder, it eliminates error codes for 99% of cars, ensuring a seamless upgrade to LED headlights. The all-in-one design allows for a quick plug-and-play installation, taking just 5-10 minutes. This advanced generation product provides stability and reliability, effectively stopping flickering and canceling CANBUS error warnings. Plus, our dedicated support team is ready to assist with any compatibility concerns.
J**.
Worked on my Jeep
These worked well on my 2015 Jeep Cherokee. Occasionally i will get a warning that one of my lights is out and it will turn one bulb off. I just turn the lights off and back on and it works again. Only happens once every 2-3 weeks.
J**E
Inexpensive repair, saved a bunch.
Fit as described, higher quality than the units that came with the $99 low buck L.E.D. headlights on my friends Jeep JK. Cost her about $12 instead of another $100+ to replace the headlights due to failure of unit that rendered one headlight useless. Great fix for a potentially pricey issue. Would definitely purchase again if needed. Thank you Amazin. Parts arrived sooner than expected and were exactly as advertised.
A**O
I could not find any polarity on the plug that goes into the part, so guess and reverse
ordered as backup for CAN bus car, the part seems to keep fault bulb warning away
N**N
Removed slight flashing from 2014 Ram with LEDs
I installed 3 sets of these in my low beams, high, and fog lamps after installing LEDs. They have removed the slight flashing I was getting in my 14 Ram. Day one they have done their job, showed up on time, the package looked the one from Ace Ventura after being punted down the hallway but hey they work.
C**S
Did not work for 2015 Dodge Challenger
Purchased this decoder set for my 2015 Dodge Challenger. Was excited to use my new LED bulbs but unfortunately they did not work at all. I also tried this decoder set with another pair of bulbs on another vehicle... still bad! The picture I attached is DC voltage straight from my car headlight bulb harness (13.37 VDC) and the 0.00 volts is from the decoder attached to my Challenger harness. Now I have to wait even longer for the LED set to get in that I should have ordered in the first place -- LASFIT 9012/HIR2 LED Headlight bulbs, Conversion Kits, Philips Chips 72W 7600LM 6000K Cool White with 50W Load Resistor Error Free Anti Flickering (2 sets)
W**T
I can’t contact the seller for the issue.
The install was easy but my drivers side headlight wouldn’t work. On top of that my brights wouldn’t work at all. I tested it and nothing happened. I removed it and found out that the fuse was blown. I replaced the fuse and my headlight worked, then I put the product back in line. There was a spark and the headlight didn’t turn on. Checked and the new fuse was blown. I can’t use the item because it just keeps blowing fuses on the drivers side and my brights don’t work. Bottom line it doesn’t work for a 1997 4Runner.
G**G
Eliminated DRL flicker
These got rid of the flicker with LED headlights in DRL mode on a 2016 RAV4. Note that the DRLs run at the same brightness as the regular headlamps, as opposed to the halogen lights which are dimmer in DRL mode.
R**L
Works in the 2013 Ford Focus (Flexfuel).
Worked good with my 2013 Ford Focus (Flexfuel). The yellow wire is the positive from the car head light, match that to the positive on the canbus.
Trustpilot
3 days ago
1 month ago
