Derale 15800 Electra-Cool Remote Cooler,Black

I'm using this as a cooler between an air compressor pump head and storage tank. Air leaving the compressor head is *very* hot, when it leaves the intercooler it is basically room temperature (likely a 150 to 200 degree F drop). I have the fan setup to run whenever the pump motor is activated. The fan and intercooler come pre-assembled and I was able to use the brackets directly for mounting the unit. I am pleased with the unit, but I do wish it came (or was available with) a variety of AN-8 mating connectors - the barbed fittings weren't applicable to my use case.

Great product made here in the US. Not a single fin is damaged and I bought 3 of these. Amazing product quality and packaging was good with getting it to me in that condition. Using them to cool video cards. Will be buying a couple more to cool power generators.

I wired an 8 Amp 120AC to 12V DC converter to the pump motor so the fan on the cooler only runs when the compressor is running. This cooler is plumbed between the compressor head outlet and the storage tank inlet and reduced the temperature 113.5 degrees F in its initial run from 0 PSI to 165 PSI. I have an auto-drain moisture trap between the cooler outlet and the tank which removed 2.5 oz. of water! I am VERY pleased with this coolers performance and construction.

Works great. all parts needed to plumb this aftercooler on on air compressor can be found on Amazon

As others, I'm using this as a precooler for an air compressor, and it gives about 150 degrees of temperature differential. Fan isn't the quietest, but with an automated on/off switch it isn't noticeable when the compressor is running. It would be better if the Inlet/outlet ports were supported due to the size of the fittings and low strength of the tubing to resist installation torque (yes, backup wrench is required and is warned about in the instructions, but the design could be a bit more rugged).

Installed in line to condense out water before compressed air goes into tank. Dropped temperature from 280 degrees down to 70.

I installed mine on a Ford F-350. Tying in series with the factory cooler. Then I installed the fan control switch on the line coming from the factory cooler. So if the fluid was still 180* after the factory cooler, the fan would kick on. I weighted in at 34,500lbs, truck and trailer, over several mountains and never saw a transmission temp over 215*. Where previously I would have temps up to 230* and I would be forced to slow way down or pull over. From this point on, I will be doing these on all my tow rigs even if they are new or used. I couldn’t be more pleased with these results.

Spend your money somewhere else, this cooler doesn't really help at all.my temperature keeps rising to 220 if not higher, I even took my Jeep to a shop so they would go through my setup to make sure I did everything right and everything on my side was done correctly.what a disappointment...