CorsairRS120 ARGB 120mm PWM Fans – Daisy-Chain Connection – Low-Noise – Magnetic Dome Bearing – Triple Pack – Black

I'm very happy with these fans! They work perfectly and the ARGB lighting looks fantastic in my case. They're quiet and move a good amount of air, so they're a great value for the price.My only piece of advice for other buyers is to pay close attention to the wiring. The product description or manual should show you which cables are for power and which are for the ARGB lighting. It's really important to check that these wires are designed to "daisy chain," which means you can connect one fan's cable to the next, simplifying the wiring and reducing clutter. If you take the time to plan your cable management, the installation process will be very smooth.Overall, a great purchase!

Bought 3 of these to replace the Thermaltakes which came with my CPU cooler when Thermaltake refused to RMA just the fans. Even though I bought these "used" (aka repackaged), they came in good condition and had all the parts & pamphlets that mattered. They have a high static pressure (nearly 3.5mm H2O), and are rather quiet even at max speed. Keeps temps low even on my monster 14900k. One fan did come with short cables (~3 inches), but since I chained them all on a radiator the length didn't matter. The RGB works fine, and syncs with my motherboard's other JARGB1 via OpenRGB. Looks no worse than the originals. Will update in a few months whether the quality stays high.

These are very good fans which won't break the bank. The can be a bit noisy at times, especially if you are like me, that has to have them on full power all the time. Sounds like a swarm of bees. But chances are you won't need to tweak the speed. Between the CPU, GPU, and 36TB of storage, these fans are working overtime, plus it downloads all night long and sometimes I give it a break. I highly recommend these for their price, airflow, and quality. The pix are of the same fan only white. I installed the black ones then had to get others for reasons I just stated, and I opted for the white ones. They are also as I type in my rig, but the fans are hidden by the sides and my rig is ti heavy for me to get a pic of them installed. The review was an afterthought. Apologies

Replaced a couple fractal aspect 120s with these 140s and my CPU temp at full load dropped by 5+ degrees, from mid 80s to high 70s (5800x3d with a Thermaltake Fs 140). They’re just about dead silent at idle and audible but tolerable at higher RPMs, no annoying whine or whistle with these just a rush of air. Wanted RGB for the kids and the colors and diffusion look fine to my eye. These are pricey however they don’t have rubber pads at the mount holes and they have comically short power and RGB cables which caused an additional purchase of 4 pin extension cables. A nice long RGB cable on my 120mm thermalright cpu fan had a daisy chain part to it and is the only reason I could finish the build without RGB extension cables. So these aren’t perfect but they’re fair quality with decent overall performance. Hope they last!

I installed these into an NZXT Airflow 5 case several months ago. Work great and the daisy chain is really nice to have over a hub. Theyre being used as front intake between 30-80% speed. At lower speed theyre pretty quiet and move decent air. At higher speed they sound like a wind tunnel but the motors themselves dont make much, if any, noticeable noise. I sit with the tower pretty much right on my leg (not literally) and play with a speaker on low volume. I can hear the AIO and its fans much more than the intakes. Build construction is solid and I think they are at a fine price for what you get.

A basic case fan. Thank god. And it’s a very clean design. Bought 9, populated an entire case. Above 65% fan speeds they get noisy. But that’s the point with these, buy a lot, no heat problems, no high fan speeds, quiet. Easy peasy. Daisy chain cables could be longer.. but there’s extensions for that. Not a huge deal at $38 for 3. Not paying $100+ for 3 fans and a stupid controller. I do wish Corsair made the higher quality fans without RGB as a price modifier for their high end line. They could be $65~ for a 3 pack with no RGB.

used these for H6 flow case, work great, look great. Daisy chain built into the fans so you only have to use 1 ARGB and 1 PWM if you want to you dont have to daisy chain you could use them separate if needed. Max fan speed was about 1800RPM on full power on the 140mm. Since it is forcing me to review both the 140mm 2 pack, the 120mm 3 pack, and a single 120mm fan all in one because they are different variants, i will mention them as well. the 120mm fans are great, a little loud when at 100% but the RPM max is 2100-2180, so yea its not going to be quiet lol, they are PWM 4 pin, also have daisy chain option built in, one of the products i forget which maybe the 3 pack came with 2 ARGB and 2 PWM extensions which can be useful, i had to set up the fans "sideways" not that you can tell, because the wire placement was in the way for the wire channel when upright position. What i did so the fans were not on top of another's wires was took the wires out the little holder and that gave just enough slack to not have the wires under the fan and the wires were no where near the fan blades after. I went from nzxt to these, nzxt had a lower rpm rate on both 140 and 120s, therefor was more quiet, but i am fine with the noise, i have a headset on 90% of the time im using the PC lol. So crank away. 5 star on all products, would recommend, good quality, high RPMs, ARGB!, style is great, would 100% recommend the 120mm fans to put on a radiator as they have a high rpm and push pretty good, the 120 fans on my cooler master max rpm is like 1800 so i almost want to swap them for the extra pressure.