Powerty Cargo Cover for Toyota Corolla Cross 2022-2025 Accessories Retractable Trunk Cover Rear Trunk Security Cover Shielding Shade Black（Not for Corolla）

I really like this cargo cover and it fits the car perfectly. It was quick and easy to install, and the quality is amazing. I also like that it has a handle you can use to help open and close the cover. It does have a small gap right behind the seats but it doesn't bother me as it does its job by keeping everything covered and you don't even really notice the gap unless you are looking right over it.

Perfect fit, easy installation. Must be removed to lower the back seat.

This fit perfectly and works great! Looks exactly as pictured and is a heavy duty material. I lay my Carhartt jacket across the top of it to dry all the time.

I purchased this for a 2025 RAV4. It fits perfectly and looks like factory-installed. Seems to be good quality and much less expensive than purchasing through Toyota. One small complaint - as other purchasers have noted, there is a gap between it and the rear seat, so anyone looking in the car through one of the rear windows can see into the area of the trunk nearest the rear seats. Wish the manufacturer had considered adding a small flap. But would still recommend to anyone looking for a trunk cover.

Love this cargo cover! It is perfect in my 2023 Edge. I will probably never attach the hooks to the back seat headrest as it would make putting the back seat down more difficult but it does not bother me, nor is it visible when not attached. 5 ⭐️’s on this one!

Fit my 2017 Ford Edge perfectly. It was a little awkward climbing in the back seat to attach it but, overall, a very easy installation. I love that I can cover anything that I have in the back of my car. It looks great!

The item is as described and fits my 2015 Audi Q5, providing good coverage of the cargo bay. The only thing that didn't fit was the cord that attaches to the hitch to lift it when the hitch lifts. I needed to tie a knot in the cord to shorten it. Also, one of the cords was slightly frayed, but it's holding up well for now. I'd say it's not bad enough to warrant a full return or exchange.

I have a honda hrv ex 2022. I installed this cover in late March on a cold day, somewhere in the low 20 degree range. 1. I heated up the adhesion strips a little with a hair dryer, not too much. Because it was cold and adhesives may not adhere in cold, just to give a boost. I wouldn't do it if warmer. 2. I pried up the rubber gasket with a very wide plastic putty knife. Takes some fiddling to get the bracket seated all under. 3. The brackets installed under the rubber gaskets but were not an exact fit. I was not going to try to remove the gaskets, as they were in solid and I didn't want to make leaks. So there was no place for the hooks to fit into. This made the brackets not fit the curve of the car easily. 4. I used a lightweight orange plastic mallet to persuade the bracket to conform to the curve and the adhesive to adhere. I tapped it lightly then more firmly, but not real hard. One of the hooks broke off, but that made it fit better. I think that happened with the second one, too, though the hook didn't pop out like the first one. Finally they seemed stable enough. 5. The rest of the process was easy, just sliding in the shade/fabric assembly at an angle, just a little fiddly. Not sure yet about the straps that fit around the headrests of the rear seats, since my hands were too cold by this time, and will finish it later but it looks like they will work fine. I'll store the (generous) extra adhesive pad in a zip loc indoors, since it seems I may need it. Maybe when it's warmer. I'll keep the red peel off backing to use as a template for when I need to use the adhesive. I'm a woodworker who builds furniture and have custom built and installed cabinets in a couple of kitchens, so I'm not afraid to experiment like this. ymmv It's very heavy sturdy fabric and easy to open and close, so I'm very happy with that part. The assemply looks like it will last Also, it doesn't have a gap like some of the others. Pretty sure this is much nicer than the other I've looked at online including the dealer ones that are more expensive. Quality and price are good. I removed a star for fit of the brackets without removing the rubber gasket and ease of assembly. Unless you work a lot with cars/body work, etc. I wouldn't recommend separating the gasket from the car unless it comes out easily. Mine was very tight, and I wanted it to stay that way. Hope this helps someone else. It can work, but a lot of fiddling and persuasion. I'd buy it again, but might wait for warmer weather. Also, the little squares with the prep for adhesion are too small. Not sure what to use if they need to be replaced. Probably need to contact the company.

I put off buying a new cover from Honda after I lost mine (don't ask). They were so expensive. I finally tried this one instead. It fits perfectly and is not as flimsy and flexible as the one that came from Honda. Why did I wait so long to do this?

great quality and much cheaper that toyota OM parts

Perfect fit. Works really well with the extra handle (OEM don't have handle). Great price.

I use this thing all of the time…just love it!

Fast delivery, good quality, good price, and easy to install. No help needed to install. I got what I wanted for my money.