1/4 Inch F6 Wrap-around Braided Sleeving- 10ft- Black

Installed a set of Hyper-Lite 3 Way LEDs on my 2012 Suzuki DL650A.While the wires used with the Hyper-Lite did not need any cover, I decided it did not look as good as I wanted it.So I used this product (1/4" ID) to cover the Hyper Lite LED wires.PROLooks greatHigh Quality ProductCovers 4 wires together of 18 gauge wires that had already been wrapped in electrical tape (So likely would hold 6 to 8 similar sized wires)CONCut edge sometimes is not clean and you many want to cut the end a few times till you get a clean square cut...Wish I had found this type of product years agoA little high in cost for the productOVERALLLooks much better than tie wrap cables. Easy to use. Holds well on a motorcycle. Would recommend to others

Works great, used it to wrap some wires on a motorcycle. Looks far better than the plastic split loom.

good material. easy to use

Had wire harness covers that were cracking and splitting. This covered and protected the wires while looking good. Easy to install.

This stuff is the answer for containing/bundling wires in any situation. A bit awkward to install 'til you get the hang of it. Have used it under the hood of the Mustang to tidy up smaller wiring and below my desk for smaller PC cables. Durable as the dickens, but it wants to unravel at the cut ends. Heating with a match helps some but is not a total solution for this. Nonetheless a great product.

Look somewhere else, this is hard to use, only holds 2 cords, very stiff

Used this to hide the under hood lights . Looks wayyy better then corrugated loom.

Good sleeving. I needed to add protection to some wires and this does a decent job keeping the wires together and away from moving parts.