APTIV Micro-Pack 100W 18 20 GA, PCM Terminals (Pack of 12)

Great! Used them to pin my E85 sensor in my Gen3 Sierra to my P59 ECU.

Very easy to attach to wires, and can be done with a set of small pliers. Works very well for adding features like E-fans with proper A/C controls to my 0411 PCM and adding the necessary wiring for 4L80E swaps.

They worked very well.

These will work for the Holley terminals

I was doing the Efan conversion on my 04 Silverado and needed to add two wires of the harness high speed and low speed. I looked around and no one made it clear if these fit a 3rd gen lm7 5.3 computer with the green and blue connectors on the ecu well they do! Don’t hesitate to buy these. The only issue I had was getting them to grab onto the wire and installing them in the right hole without bending but with time and patience it’ll work out!

Worked well

I had this somewhat crazy idea of adding directional signals to my RZR. I had planned to add two indicator lights to let me know they were on. Then I happened to glance at my dash in just the right light, and could see it had directional signal arrows built in. A quick look at a wiring diagram showed which two pins on the instrument panel connector were connected to the right and left indicators. I'm 70 years old, and my hands and eyes no longer do real well with detail work, but installing these pins in the connector was not terribly hard, and did not require any special tools. I ran wires from the newly installed pins to the left and right circuits I was installing. upon powering the system up, the dash indicators flashed right along with the turn signals. Note I did NOT have to add bulbs to the dash. The dash came with LED's or bulbs already in place.

Perfect fit for my 02 silverado pcm connector.