ZOOKOTO 0/2/4 Gauge in 4/8/10 Gauge Out Amp Power Distribution Block Car Audio Splitter 2 Way Outputs Power Distributor Block Fuse Holder

Works just fine.

I have 4x door speakers that run ~90-100W RMS each at maximum load (without distortion) and 2x shallow mount subs that draw up to 250W RMS each that are all fed by both a Pioneer GM 8704 and a NVX mono block 750W RMS amp. Zero issues connecting the two amps using this splitter. I've got a 4 gauge stepping down to 8 gauge connectors that are less than 4' long each so I get plenty of power delivered without loss due to distance. Great device if you want to keep your cable runs cleaner and just have one power cable running to your equipment.

These are okay. Would not buy again. The terminals are not connected to the base very well. Seem loose but have not fallen off. Verified there is no resistance added going through the splitter with ohm meter.

Muy util para distribuir corririente

Exactly what I needed to power 3 amplifiers in my car. A much better solution than running 3 individual power wires from the battery and cheaper. I only had to run one 0ga power to this block then 3 smaller gauge power wires to the amps just a short distance away. I will be purchasing another one to combine all the grounds because it will clean up the cable mess and I will only have to drill for one bolt hole on the chassis.

Can't complain does what it's supposed. Put this T going to my trunk battery then to my fuse box then the main wire goes to the engine bay.

Seems like this was used. Haven't yet installed it yet but it is discolored in the input hole. Hope that's not a problem. Will update once it is integrated.

Using to split 0 gauge main supply from car battery out to smaller fuse blocks and the starter. Works great. Build quality is good, looks nice in the cabin.

Looks good